User Manual

MTI RFID Reader Operation Manual PAGE: 12
43-RFID0900-E1-MANUAL
DATE: 18-04-2006
台揚科技股份有限公司
MICROELECTRONICS TECHNOLOGY INC.
ISO 9001 Certified
Chapter 3 – Configuration
3.1 Ethernet Overview
When the reader is installed on a TCP/IP network connected to the internet, the
reader must be assigned a unique IP address. The default IP address is set as
192.168.1.200, and the default subnet mask is set as 255.255.255.0, when the
reader is shipped from factory. All these can be set by using web browser.
Beside, the gateway, destination IP address, destination port, and setup password
can be set as the same way as above.
.
Note:
 The default setting of destination IP address is set as 192.168.1.39
 The default setting of destination port is set as 100
 The default setting for the setup password is set as empty.
3.2 IP Address or Subnet Mask Setup
To set up IP address of RU-813 for Ethernet communication, perform the following
steps:
1. Verify all cables and power supplies are secure and power up the readers.
2. Set the subnet mask of host computer to the same subnet domain of reader.
3. Open Web browser (IE or Netscape) on your host computer.
4. Type IP address at web address on the browser.
5. Enter password (the default password is empty), then click “Login”.
6. Change IP address.
7. Change subnet mask, if necessary.
8. Click “Update”
MTI Group Proprietary Information
Any unauthorized use, duplication, reproduction, or disclosure of this document may be
considered as infringement of MTI Group’s intellectual property rights, the infringer may
be accused and liable applicable legal penalties.
台揚集團智慧財產
任何未經授權逕予複製、重製、公開或使用本文之行為，將被視為侵害
台揚集團之智慧財產權，將可因此負擔法律責任。