User Manual

MTI RFID Reader Operation Manual PAGE: 10
43-RFID0900-E1-MANUAL
DATE: 18-04-2006
台揚集團智慧財產
任何未經授權逕予複製、重製、公開或使用本文之行為，將被視為侵害
台揚集團之智慧財產權，將可因此負擔法律責任。
MTI Group Proprietary Information
Any unauthorized use, duplication, reproduction, or disclosure of this document may be
considered as infringement of MTI Group’s intellectual property rights, the infringer may
be accused and liable applicable legal penalties.
台揚科技股份有限公司
MICROELECTRONICS TECHNOLOGY INC.
ISO 9001 Certified
2.2.1 Hollow Concrete Block Wall Mounting
To temporarily mount theRU-813 to a hollow concrete block wall, MTI
recommends metal sleeve type concrete anchors that accept a #10 screw
and flat washer. To install the reader on a hollow concrete block wall, perform
the following.
1. Refer to Figure 4, and mark the location of the mounting screws. Do not
install the anchors into the mortar joint.
2. Drill the appropriate size hole for a metal sleeve type anchor.
3. Install the anchors.
4. Install the washers and insert the screws.
5. Tighten the screws to within .375” of the anchor.
6. Install the reader and finish tightening the screws.
2.2.2 Solid Concrete Wall Mounting
To temporarily mount theRU-813 to a solid concrete wall, MTI recommends
one-piece expansion type concrete anchors that accept a #10 screw and flat
washer. To install the reader on a concrete wall, perform the following.
1. Refer to Figure 4, and mark the location of the mounting screws.
2. Drill the appropriate size hole for a expansion type anchor and install the
anchors.
3. Install the washers and insert the screws.
4. Tighten the screws to within .375” of the anchor.
5. Install the reader and finish tightening the screws.
2.2.3 Wood or Metal Wall Mounting
To temporarily mount the RU-813 to a wood or sheet metal wall, MTI
recommends either #10 x 1 inch wood screws or #10 x 3/4 inch sheet metal
screws and washers. To install the reader on a wood or metal wall, perform
the following.