Installation Instructions

ManualsBrandsMicroelectronics Technology ManualsElectronicsWIRELESS OUTDOOR BRIDGE SYSTEM

Chapter2 Hardware Installation

This chapter provides installation procedures are generally outlined as follows:

 Verify system configuration

 Installing the ODU

 Installing the POE

 Mounting and alignment the antenna

 Connecting external equipment

You may need to use Web Browser to

change or set the MTIBR5811(E1) system’s

operating parameters. Refer to chapter 3,

Bridging network attachment and configuration, for more information.

2-1 Unpacking the Equipment

The tools required for unpacking the system equipment are:

 Utility knife

 Clean, flat working surface

Open the shipping containers, carefully remove the equipment and place it on a

clean, flat working surface. Save the shipping and packing material in case the

equipment has to be returned.

Check the equipment and installation kits against the packing list to ensure that

the equipment part numbers, parts, and ancillary equipment included in the

shipment match what is specified on the packing list. Shipments consist of an

ODU and an installation kit in one container. Verify the configuration as

described in verifying the System Configuration. If there are discrepancies

between the packing list and the equipment received, contact your sales

representative.

Inspect the equipment for any type of shipping damage. If any part of the

shipment is damaged, contact your sales representative for repair or

replacement instructions.

2-2 Verifying the System Configuration

The MTIBR5811(E1) system consists of an Outdoor Unit (ODU), POE and an

installation kit.

Summary of content (7 pages)

PAGE 1
Chapter2 Hardware Installation This chapter provides installation procedures are generally outlined as follows: Verify system configuration Installing the ODU Installing the POE Mounting and alignment the antenna Connecting external equipment You may need to use Web Browser to change or set the MTIBR5811(E1) system’s operating parameters. Refer to chapter 3, Bridging network attachment and configuration, for more information.
PAGE 2
-3 Installation Kit Most of the materials needed for installation are supplied with the system. Some tools and equipment must be supplied by the user. Table lists materials in a typical installation kit. Refer to the packing list for a description of the exact contents. Table Installation Kits (for 2” Steel or Stainless Steel Tube) Item Description 1 2 3 4 5 M-TYPE PLATE L-TYPE PLATE U-TYPE PLATE NUT FLANGE M8-1.25 SS (PLATE ASM) NUT FLANGE M8-1.
PAGE 3
2-6 Outline of MTIBR5811(E1)
PAGE 4
2-7 Installing the ODU The MTIBR5811(E1) can be mount on a 2” Steel or Stainless Steel Tube. You can reference the Figure. ODU Configuration You can refer the photo here for installation.
PAGE 5
PAGE 6
2-8 Connecting the cable An Ethernet cable connects the ODU to the POE output port. The cable connects power to the ODU and allows Ethernet data to flow between Stations with Bridge system. Another Ethernet cable connects the station to POE input port. AC power is applied to the bridge system by connect it to POE AC adapter. 2-9 Align the Antenna (TBD) Notices The RSSI BNC connector is still not function well now. Please use the RSSI reading from the statistics window in WEB -base browser.
PAGE 7
. Repeat these steps as necessary to get an accurate reading. 8. Tighten all fasteners and check that the null has not changed. If the null has changed, repeat the procedure until the null is maintained after tightening the fasteners. 9. Disconnect the voltmeter and replace the RSSI protective cap. Note: The signal level over the link is not optimal until both antennas are correctly aligned.