User's Manual

802.11a Bridge AP5822 MTI Proprietary Page 25
3-8 System Basic Configuration Window
The System Basic Configuration window allows the setting of general operating information
for the Bridge. Click on Configuration from any window to access the System Basic
Configuration window (see Figure).
Bridge System Basic Configuration Window
Set the value of default gateway address to PC IP or router port IP.
Other settings can also be changed at this time.
Table A-2 summarizes the data fields on the System Basic Configuration window.
Table A-2. System Basic Configuration Window Field Descriptions
General Configuration Field Description
SSID Identification of the Bridge. Enter a number or address betwe
en 1 and 32
characters in length that the STAs
are associating with in Infrastructure
mode. More than one Bridge in an SSID can be specified here. Use
the
System Name field to uniquely identify each Bridge.
Suppress SSID
Use the checkbox to prevent broadcast of the Bridge’s
SSID in
beacons. When enabled, the SSID in beacons
are not transmitted and
only those STAs with prior knowledge of an Bridge’
s SSID can
associate with that Bridge.
System Name Specifies a unique name for Bridge. Enter a unique text str
ing of up to 32
characters in length. Both bridge A and B must have the same system
name.
Wireless Mode The wireless LAN mode specifies both frequency range and data rates.
Enable 5GHz Outdoor Channels Click this button to Enable 5GHz radio operation
Radio Frequency (MHz) Select the desired frequency of operation from the drop-down menu.
The
radio frequencies that appear in the Radio Channel drop-
down menu are
dependent on the wireless mode selection.
IP Address Specifies the IP address of the Bridge.
Subnet Mask Specifies the subnet mask for the Bridge.
Default Gateway Address Specifies the default gateway for the Bridge.
User Name Specifies the user name.
Password Specifies the pas sword.