Specifications

66
[Range]
[Description]
[Notes]
[Reference]
n = 1, 49
Transmits the status specified by n as follows:
N Function
1, 49 Transmits paper sensor status and paper end sensor status
 This command is valid for serial model and / or USB model only. If printer has serial
and USB interfaces, data is returned to serial and USB interfaces at the same time.
 The status types to be transmitted are shown below:
Paper sensor status (n = 1, 49):
Bit Off/On Hex Decimal Status for ASB
Off 00 0 Paper near-end sensor: paper adequate 0, 1
On 03 3 Paper near-end sensor: paper near end
Off 00 0 Paper end sensor: paper adequate 2, 3
On 0c 12 Paper end sensor: paper end
4 Off 00 0 Not used. Fixed to 0.
5,6 Undefined
7 Off 00 0 Not used. Fixed to 0.
DLE EOT
GS w n
[Name]
[Format]
[Range]
[Description]
[Default]
[Reference]
Set bar code width
ASCII GS w n
Hex 1D 77 n
Decimal 29 119 n
2 ≤ n ≤ 6
Set the horizontal size of the bar code.
n specifies the bar code width as follows:
Binary-level Bar Code
n
Module Width (dots) for
Multi-level Bar Code
Thin element width
(dots)
Thick element
width (dots)
2 2 2 5
3 3 3 8
4 4 4 10
5 5 5 13
6 6 6 15
♦ Single-level bar codes are as follows:
UPC-A, UPC-E, JAN13 (EAN13), JAN8 (EAN8), CODE93, CODE128
♦ Binary-level bar codes are as follows:
CODE39, ITF, CODABAR
n = 2
GS k