Specifications

31
ESC c 1 nL nH
[Name]
[Format]
[Range]
[Description]
[Notes]
Set cutting position
ASCII ESC c 1 nL nH
Hex 1B 63 31 nL nH
Decimal 27 99 49 nL nH
0 ≤ nL ≤ 255; 0 ≤ nH ≤ 255;
N=(nL + nH x 256 )( If n < 19, n = 19)
Sets the cutting position to a place when marked paper is selected.
• Direction settings: feeding paper is front, reversing feed paper is back.
• The relationship between N and the cutting position is defined as below.
If n increase, the cutting position move backward； If n decrease, the position move
forward : n/8（mm）for 203DPI, n/12（mm）for 300DPI.
• When nL = nH = 255, the N saved to printer will not loss even when printer is turned
off/on.
ESC c 3 n
[Name] Select paper-end signal of paper sensor
[Format] ASCII ESC c 3 n
Hex 1B 63 33 n
Decimal 27 99 51 n
[Range] 0 ≤ n ≤ 255
[Description] Select paper sensor to output paper-end signal
• The definition of n bit is as follows：
Bit 0/1 Hex Decimal Function
0 0 00 0
undefined
0 00 0
Paper-near-end sensor is not available
1
1 02 2
Paper-near-end sensor is available
2 0 00 0
undefined
0 00 0
Paper end sensor is not available
3
1 08 8
Paper end sensor is available
4-7
undefined
[Notes] • It is possible to select two sensors to output signals. Then, if any of the sensors detect a paper
end, the paper end signal is output.
• The command is available only with a parallel interface and is ignored with a serial interface.
[Default] n = 0