Operator`s manual

Appendix

Self-test Page

Print self-test page in the following steps:

• Turn off the printer power.

• Hold the feed button for at least one second while turning on the power.

The printer will start to print a self-test page. Take the 203 dpi, Serial + USB interface model as an example.

The self-test paper is shown as follows:

***MICROCOM814M-3 TEST FORM***

Boot Firmware :FV2.010

Main Firmware :FV2.050

H/W Parameters

H/W ID :MICROCOM814-3(U) 1

Flash Memory Size :1M bytes

Flash Logos Size :64k bytes

Resolution :300×300DPI

Print Width (Max) :216mm

Fixed Left Margin :2mm

Fixed Right Margin :2mm

Print Speed (MAX) :75mm/s

Dark Scale :100

Cutter :Enabled

Paper Roll Width :216mm

Presenter :Enabled

Presenter Mode :Keep Paper

Presenter Wait Time :3s

Communication Interface

Rx Buffer Size :4K bytes

Interface Type1 :RS232

Baud Rate :38400bps

Data Bits :8

Stop Bits 1

Parity :NONE

Flow Control :DTR/DSR

Command CR :Disabled

Data Receive Error :Ignored

Interface Type2 :USB_ORU

Resident Fonts

Font0 (18x34) :English

Font1 (13x24) :English

Code Pages :437,850,852

:858,860,863