Operator`s manual

Chapter 5 Printer Commands
48-466 Operators Manual 37
^A ^D COMMAND
24 Change SW4: Change software dip switch #4. Below is the ^AB sequence.
12345678
^ABxxxxxxxx
*******.)))))),
******.)))))),*
*****.)))))),**
****.)))))),***
**** 0000 = Not decoded (8 bit)
**** 0001 = Danish (7 bit)
**** 0010 = 860 (8 bit)
**** 0011 = Spanish (7 bit)
**** 0100 = 850 (8 bit)
**** 0101 = German (7 bit)
**** 0110 = 865 (8 bit)
**** 0111 = Swiss (7 bit)
**** 1000 = 852 (8 bit)
**** 1001 = French (7 bit)
**** 1010 = 863 (8 bit)
**** 1011 = Italian (7 bit)
**** 1100 = 437 (8 bit)
**** 1101 = Swedish (7 bit)
**** 1110 = British (7 bit)
**** 1111 = US English (7 bit)
****
***.)))))Q Always 0
**.))))))Q 1=Blow-hole Sensing Enable, 0=Disable
*.)))))))Q Always 0
.))))))))Q Always 0
Position:
1 Always 0
2 Always 0
3 Blow-hole Stock: Enable this position when using blow-hole or cut-slot stock: Stock
that uses a hole instead of a gap to separate labels.
4 Always 0
5 Code Page Selection
6 Code Page Selection
7 Code Page Selection
8 Code Page Selection