Operator`s manual

Printer Commands Chapter 5
48-466 Operators Manual36
^A ^D COMMAND
23 Change SW3: Software dip switch #3. Below is the ^AB sequence:
12345678
^ABxxxxxxxx
*******. Detect Black Line On Power-up
******.Q Always 0
*****.)Q Always 0
****.))Q Always 0
***.)))Q Always 0
**.))))Q 1=Send Response After Print
** 0=No Response After Print
*.)))))Q Always 0
.))))))Q 1=Disable Extended ASCII, 0=Enable
Position:
1 Extended ASCII: If enabled, characters over 7F hex will be processed.
2 Always 0
3 Response After Print: If enabled, an enquiry response will be sent back through the
serial port after every print.
4 Always 0
5 Always 0
6 Always 0
7 Always 0
8 Detect Black Line on Power-up: If this bit is set, the printer will automatically run
a few labels and correctly set the ^D91 value.