Operator`s manual

Printer Commands Chapter 5
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
470 Operators Manual
48
^A ^D Command
25 Change SW5: Change software dip switch #5. Below is the ^AB sequence:
12345678
^ABxxxxxxxx
*******.) Not Used
******.)) 1=Enable Auto Error Message Transmission
*****.))) Not Used
****.)))) Not Used
***.))))) Auto Adjust for Black Line Darkness
**.)))))) Not Used
*.))))))) Not Used
.)))))))) 1=Disable Name/Time When Idle, 0=Enable
Position:
1 Name/Time when idle: When set to 0, the printer will display the default or
programmable message (^D78) on the first LCD line and the current time on the
second LCD line.
2 Not Used
3 Not Used
4 Auto Adjust for Black Line Darkness: When set to 1, the 470 will
automatically adjust the D91 setting to the correct value on power-up.
5 Not Used
6 Not Used
7 Auto Error Message Transmission: When set to 1, all catastrophic error
messages will automatically be sent to the serial port. (see Table 9)
8 Not Used
26 Change SW6: Change software dip switch #6. Below is the ^AB sequence:
12345678
^ABxxxxxxxx
*******.) Not Used
******.)) Not Used
*****.))) Not Used
****.)))) Not Used
***.))))) Not Used
**.)))))) Not Used
*.))))))) Not Used
.)))))))) Not Used
Position:
1 Not Used
2 Not Used
3 Not Used
4 Not Used
5 Not Used
6 Not Used
7 Not Used
8 Not Used