Instruction manual

©INCOE® CORPORATION 8/2010
Pg. 28
www.incoe.com
2
M SERIES
INSTRUCTION MANUAL
OPERATION
The following page is displayed when the diagnostic
is over: A message asking if saving is required is
shown.
Tip: It is recommended to save values of the Analysis
by selecting YES with the left and right arrows, then
enter.
Notice: the Analysis is carried out on all zones if no
specific zone is selected. Otherwise, the Analysis is
carried out only on the selected zones.
The status of each zone is shown on the main page
when the Analysis is over.
The icon shown above is displayed in
case of :
- Blown fuse.
- Wrong load (heater) connections.
- Triac short circuit.
- Current value measures is different from the saved
value during Analysis.
2.28 DISPLAY RESULTS
Press MEAS to display results when the Analysis of
the control zones is over.
The page below is displayed:
The first parameter displayed is the reference current
value saved during the Scan process.
Select other parameters with the keys and
such as current measurement (in Amps), applied
power (in Watts) etc….
Notice : When in the page for current measurement,
press menu DIAG to carry out a new measurement
on one or more zones selected previously (see page
below).
DIAG enables current measurement
independently on one or
more zones.