Instruction manual

Pg. 27
www.incoe.com
©INCOE® CORPORATION 8/2010
2
M SERIES
INSTRUCTION MANUAL
OPERATION
2.27 START MOLD ANALYSIS
The following page is displayed when pressing the
SCAN menu:
With the direction arrows, select YES and enter to
start a MoldScan Analysis.
By pressing NO, the MoldScan diagnostic will not
be carried out.
The following page is displayed when you select
YES and enter:
Select YES for “Advanced Data Analysis” and validate.
This starts a detailed Analysis of control zones and
to define all parameters described in 14.2. If you
select NO, a shorter Analysis will be carried out. All
parameters described in 14.2 except the response
time (in degree /minute).
The info page below is shown to confirm the start of
the Analysis:
The Analysis (advanced or not) lasts for a certain
time (depending on the number of zones inside the
cabinet).
During Analysis, data is displayed in real time in
page shown below:
Zone wattage
Zone resistance
Thermocouple status
Temp. response time