User manual

NANO-GX User Manual
Page 80
Step 4: Connect the SATA power cable. Connect the SATA power connector to the
back of the SATA drive. See
Figure 4-14. Step 0:
Figure 4-14: SATA Power Drive Connection
4.5.5 Audio Kit Installation
The Audio Kit that came with the NANO-GX connects to the 10-pin audio connector on the
NANO-GX. The audio kit consists of three audio jacks. One audio jack, Mic In, connects to
a microphone. The remaining two audio jacks, Line-In and Line-Out, connect to two
speakers. To install the audio kit, please refer to the steps below:
Step 1: Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.
Step 2: Align pin 1. Align pin 1 on the onboard connector with pin 1 on the audio kit
connector. Pin 1 on the audio kit connector is indicated with a white dot. See
Figure 4-15.