User manual

NANO-GX User Manual
Page 76
Figure 4-10: IDE Cable Connection
Step 3: Connect the cable to an IDE device. Connect the two connectors on the other
side of the cable to one or two IDE devices. Make sure that pin 1 on the cable
corresponds to pin 1 on the connectorStep 0:
4.5.2 Keyboard/Mouse Y-cable Connector
The NANO-GX is shipped with a keyboard/mouse Y-cable connector. The
keyboard/mouse Y-cable connector connects to a keyboard/mouse connector on the
NANO-GX and branches into two cables that are each connected to a PS/2 connector,
one for a mouse and one for a keyboard. To connect the keyboard/mouse Y-cable
connector, please follow the steps below.
Step 1: Locate the connector. The location of the keyboard/mouse Y-cable connector
is shown in Chapter 3.
Step 2: Align the connectors. Correctly align pin 1 on the cable connector with pin 1 on