User manual

NANO-GX User Manual
Page 65
Step 1: Locate the SODIMM socket. Place the NANO-GX on an anti-static pad with the
solder side facing up.
Step 2: Align the SODIMM with the socket. The SODIMM must be oriented in such a
way that the notch in the middle of the SODIMM must be aligned with the plastic
bridge in the socket.
Step 3: Insert the SODIMM. Push the SODIMM chip into the socket at an angle. (See
Figure 4-1)
Step 4: Open the SODIMM socket arms. Gently pull the arms of the SODIMM socket
out and push the rear of the SODIMM down. (See
Figure 4-1)
Step 5: Secure the SODIMM. Release the arms on the SODIMM socket. They clip into
place and secure the SODIMM in the socket.Step 0:
4.2.5 CF Card Installation
NOTE:
The NANO-GX can support both CF Type I cards and CF Type II cards.
For the complete specifications of the supported CF cards please refer
to Chapter 2.
To install a CF card (Type 1 or Type 2) onto the NANO-GX, please follow the steps below:
Step 1: Locate the CF card socket. Place the NANO-GX on an anti-static pad with the
solder side facing up. Locate the CF card.
Step 2: Align the CF card. Make sure the CF card is properly aligned with the CF
socket.
Step 3: Insert the CF card. Gently insert the CF card into the socket making sure the
socket pins are properly inserted into the socket. See
Figure 4-2. Step 0: