User manual

NANO-GX User Manual
Page 61
4.1 Anti-static Precautions
WARNING:
Failure to take ESD precautions during the installation of the
PM-LX2-800 may result in permanent damage to the PM-LX2-800 and
severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the PM-LX2-800. Dry climates are especially susceptible to ESD. It is therefore
critical that whenever the PM-LX2-800 or any other electrical component is handled, the
following anti-static precautions are strictly adhered to.
Wear an anti-static wristband: - Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
Self-grounding:- Before handling the board touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
Use an anti-static pad: When configuring the PM-LX2-800, place it on an
antic-static pad. This reduces the possibility of ESD damaging the
PM-LX2-800.
Only handle the edges of the PCB:-: When handling the PCB, hold the PCB
by the edges.
4.2 Installation Considerations
NOTE:
The following installation notices and installation considerations should
be read and understood before the PM-LX2-800 is installed. All
installation notices should be strictly adhered to. Failing to adhere to
these precautions may lead to severe damage of the PM-LX2-800 and
injury to the person installing the motherboard.