Specifications

Model 160P Stacker – Basic Operation Chapter 3
6 MODEL 160P STACKER – Quick Reference Guide
3.2 MODEL 160P STACKER OVERVIEW
3.2.1 ADJUSTABLE “TOP OF STACK” LEVER
This unique feature provides a manual adjustment for the desired maximum stack
height. Once the media in the stacker reaches the “Top of Stack” lever height location,
the stacking and printing process is halted until user intervention. This condition is
referred to later in this document as “Stacker Full”.
The Stack height adjustment is performed by sliding the “Top of Stack” lever to the
desired height. A ruler label has been provided on the Model 160P for stack height
reference. The minimum adjustment can be set to a 1.5” high stack or approximately
200 .007” thick tags. The maximum adjustment can be set to a 9” high stack or
approximately 1250 .007” thick tags. The Factory default position will be set to the
maximum stack height.
3.2.2 REMOVABLE STACK CARTRIDGE
The Removable Stack Cartridge allows the user to remove a full stack of media at one
time from the Model 160P.
CAUTION: DO NOT OPERATE STACKER WITHOUT CARTRIDGE INSTALLED.
3.2.3 CARTRIDGE BACKSTOP
The Cartridge Backstop is used to adjust the stacker for various lengths. The Model
160P has a fixed media length of 1.91”, which is set from the Factory with a socket-
head Allen screw. No field adjustment should be necessary.
3.2.4 CARTRIDGE REMOVAL PROCEDURE
1.) Printing and Stacking Process must be stopped if not
already in a paused or halted condition.
2.) Raise Sliding Stack Weight to the top of the stacker.
3.) Remove Cartridge.