Operator`s manual

Quick Reference Command Summary Appendix B
466 Operators Manual88
XX 88 Load Field Number to Increment by 1: For multiple serial numbers.
XX 89 Load Field Number to Decrement by 1: For multiple serial numbers.
XX 90 Piezo Beep Control: Enter number of times to beep pieze before turning it off.
This setting is used to control the number of times that the pieze beeps after an
error occurs. A value of 0 will produce a continuous beep.
XX 91 Load Value for Printer to See Valid Gap. Section 5.3.
XX 92 Load Value for Slices to Process: This command adjusts the number of slices
generated before the drive motor starts moving. The default is 256 and the
valid range is 1 to 366.
93 Load Control Code Recognition Status:
0 Enable control code recognition.
1 Disable control code recognition.
94 Piezo On/Off:
0 Enable piezo.
1 Disable piezo.
XX 95 Load User Defined Steps for Label to Advance:
XX 96 Load Advance Delay: ^A specifies how many milliseconds to delay
repositioning of the label in tag/tear and peel-and-dispense modes.
97 Tag/Tear Operation:
0 Turns off tag/tear operation.
1 Advance after every label.
2 Advance after copies count.
3 Advance when idle.
98 Peel-and-Dispense Mode: Sections 2.5.2 and 5.3.7
0 Turn off peel-and-dispense mode.
1 Turn on peel-and dispense mode.
2 (Custom Applicator Mode - peel and dispense with no delay.)
99 Cutter Control:
0 Disable cutter.
1 Enable cutter.
100 Clear User RAM: This command will clear all downloaded fonts, graphics, and
stored label formats. See Section 5.3.8.
101 Send User RAM Available: The printer will send the number of free bytes to the
serial port (ie. >699842<).