Operator`s manual

90
XX 47 Load label control byte (LCB): Preceded by ^A.
XX 48 Load number of steps to activate gap detector (AGD): Preceded by ^A.
XX 49 Load number of steps past gap (SPG): Preceded by ^A.
XX 50 Load X direction offset (OFX): Preceded by ^A.
XX 51 Load Y direction offset (OFY): Preceded by ^A.
XX 54 Send Non-Volatile Saved Format File to Serial Port: ^A selects which the file
to be sent (1-32). Section 5.3.6.
XX 55 Select Default Label Layout: Select from the ROM power-up layouts. ^AXX
ranges from 1 to 8.
56 End User Defined Field Definitions: Tells the printer that all field definitions are
complete.
57 Enter Label Format Mode: This tells the printer that information for a label is
following.
XX 58 Process Non-Volatile Saved Format File: ^A selects which one (1-8). Section
5.3.6.
XX 59 Save Format File: ^A selects which one (1-8). Section 5.3.6.
60 Clears command 61
XX 61 Mark Text Starting Position: ^A designates which text field to start entering new
data. Section 5.3.8.
62 Pre-padded Text: This command is sent after text that is to appear at the
beginning of each field is sent.