Operator`s manual

89
XX 36 Adjust Contrast Base: A battery backed ram command. The ^AXX is between 10
and 200%. Section 5.3. This command should only be used to adjust/calibrate head
base contrast differences between printers. Use ^D35 in normal use.
37 Check Voltages: This command will send the current power supply voltages and
head temperature measurements to the communications port.
39 Auto-Size Label: Section 5.3.3.
0 Clears the use of auto-size values set by ^A1^D39.
1 Uses the values obtained instead of those in the format file.
2 Automatically sizes the label and send the results out the serial port.
3 Same as ^A2^D39, but prints the values on a label, instead of on the screen.
40 Clear Commands 41-51.
XX 41 Load number of fields in layout (HFM): Preceded by ^A.
XX 42 Load label width in dots (LSX): Preceded by ^A.
XX 43 Load label height in dots (LSY): Preceded by ^A.
XX 44 Load web size in dots (WEB): Preceded by ^A.
XX 45 Load gap size in dots (GAP): Preceded by ^A.
XX 46 Load print speed (DPS): Preceded by ^A.