Operator`s manual

49
^A ^D Command
39 Autosize Label:
0 Clears the use of autosize values set by ^A1^D395.
1 Uses the values obtained for the variables above instead of what the user supplies
in the header of the file format. This will not display the variables on the screen.
2 Automatically sizes the label and displays on the screen the values for the size
variables. These values should be placed in the label header for that stock.
3 Same as ^A2^D395, but prints the values on a label, instead of on the screen.
XX 91 Load Value for Printer to See Valid Gap. Obtained from the autosize (^D39)
command. This value states the translucent properties of stock to the gap detector.
This ^AXX^D915 command should be at the beginning of all format files if
suggested ^D91 value returned from autosize is not between 50 and 70 or the
default value creates skipping over the label gap. Skipping over the label gap is
defined as the printing of one label and then the printing of a blank label. This
condition occurs because the default ^D91 value cannot adjust for stock that has
unusual translucent properties (old stock, thick tag stock, unusual backing paper,
etc.). This problem can be easily rectified by autosizing the stock.