Operator`s manual

45
^A ^D COMMAND
25 Change SW5: Change software dip switch #5. Below is the ^AB sequence:
12345678
^ABxxxxxxxx
*******.) Not Used
******.)) 1=Enable Auto Error Message Transmission
*****.))) Not Used
****.)))) Not Used
***.))))) Not Used
**.)))))) Not Used
*.))))))) Not Used
.)))))))) Not Used
Position:
1 Not Used
2 Not Used
3 Not Used
4 Not Used
5 Not Used
6 Not Used
7 Auto Error Message Transmission: When set to 1, all catastrophic error
messages will automatically be sent to the serial port. (see Table 8)
8 Not Used