Operator`s manual

44
^A ^D COMMAND
24 Change SW4: Change software dip switch #4. Below is the ^AB sequence:
12345678
^ABxxxxxxxx
*******.) European Configuration
******.)) European Configuration
*****.))) European Configuration
****.)))) 1=Pass ASCII over 7F, 0=Less than 80 only
***.))))) 1=Auto-size on Power-up Enable, 0=Disable
**.)))))) 1=Blow-hole Stock Enable, 0=Disable
*.))))))) Always 0
.)))))))) Always 0
Position:
1 Always 0
2 Always 0
3 Blow-hole Stock: Enable this position when using blow-hole or cut-slot stock:
Stock that uses a hole instead of a gap to separate labels.
4 Auto-size on power-up: When enabled, the printer automatically sizes the label
stock when turned on. The printer then uses these header values for all subsequent
label formats. See the ^D39 command in section 5.3 for more information on auto-
sizing.
5 Pass ASCII Text Over 7F: If set to 1, the printer will process characters over 7F
hex.
6 European Configuration
7 European Configuration
8 European Configuration