Operator`s manual

^A ^D COMMAND

23 Change SW3: Software dip switch #3. Below is the ^AB sequence:

12345678

^ABxxxxxxxx

*******.)

Not Used

******.)

Not Used

*****.))

1=Ribbon Break Sensor Disable, 0=Enable

****.)))

1=Pulse Tone On Piezo, 0=Continuous

***.))))

1=Head Up Error Disable, 0=Enable

**.)))))

1=Response After Print Enable, 0=Disable

*.))))))

Not Used

.)))))))

1=Piezo Sound Disable, 0=Enable

Position:

1 Piezo Sound: If set to 1, the piezo is disabled.

2 Not Used

3 Response After Print: If enabled, an enquiry response will be sent back through

the communications port after every print.

4 Head Up Error: If set to 1, head up error checking is disabled.

5 Pulse Tone On Piezo: If set to 1, the piezo is disabled.

6 Ribbon Break Sensor: If disabled, no error will occur if ribbon is out.

7 Not Used

8 Not Used