Operator`s manual

23
LCB LABEL CONTROL BYTE
This parameter selects between the various gap detection methods.
Continuous Stock: If set to a value of 2, the printer will not activate the gap detector circuit.
After all fields are printed, the printer will advance the extra distance in the SPG header
element.
Normal Stock (leading edge): If set to a value of 0, the printer will detect the leading edge of
the label (the start of the next label).
Black Line Stock: If set to a value of 1, the printer will detect the leading edge of a black
line.
Blow Hole Stock (Slot-Cut): If set to a value of 0, the printer will detect the leading edge of a
blow hole (see software dip switch #4 (^D24) for blow hole stock).
AGD NUMBER OF STEPS TO ACTIVATE GAP DETECTOR
This parameter selects the number of steps (dots) that the printer should skip before gap
sensing is activated. This value is usually defaulted. It is not defaulted when using stock
that contains pre-print or gaps that may cause the gap detector to trigger incorrectly.
SPG NUMBER OF STEPS PAST GAP
The number of steps to advance the label after detection of a label gap. Use autosizing
(See section 5.3.3) to quickly evaluate this parameter for small stock.
It may also be necessary to adjust this value if using material with a sense position not
located at the end of the stock.
OFX X DIRECTION OFFSET
This parameter moves all the fields in the X direction without changing the fields
themselves.
OFY Y DIRECTION OFFSET
This parameter moves all the fields in the Y direction without changing the fields
themselves.