Operator`s manual

Part of the 465's versatility is in the different ways it processes labels. The following two sections

explain the dispensing modes and printing methods. Refer to figures 2 and 5 for the printer

components.

2.6.1 NORMAL AND TAG/TEAR MODES

Place the label supply shaft and stock onto the wire rack. Raise the print head with the lift lever and

insert the paper with the thermally sensitive side up. Follow the loading diagram and thread the

paper through the printer and under the print head. Lower the head lift lever and you are ready to

print.

2.6.2 PEEL-AND-DISPENSE MODE

Follow the paper loading in the normal and tag mode directions. Pull out several inches of paper

and remove the labels. Be sure the leading edge of the stock is flat and square. Rotate the pinch

roller release knob and insert the paper between the black drive roller and the white pinch roller.

Remove the slack and release the pressure on the pinch roller by turning the release knob.

Printer Feed Mechanism

Figure 5