User guide

32 Visitor Administration User Guide
Printing
A printer inside the Kiosk is used to print temporary adhesive badges for visitors. It must be installed
with the proper settings.
Installing the Printer
1. Install the printer driver from the disc (\usb-serial\PL-2303 Driver Installation_v20026.exe).
2. Connect the printer to the computer.
3. Run PrnInst.exe. This will place the printer in Printers & Faxes.
a. From the list of printers, select Microcom 428M 300DPI. This information is located on the
bottom of the printer.
b. Select the COM port from the list.
4. Right-click on the printer and select Properties.
5. On the Ports tab, click [Configure Port].
6. For the Port Settings, configure the following:
• Bits per second: 115200
• Flow control: Hardware
Verify the configuration by printing a test page.
Label Settings
For labels that are 4 x 2 5/16 (2.3125") inches in size with a 3/16 (0.1875) inch gap between labels,
the following printing preferences should be set:
Options
• Paper Format: Portrait
• Size (in inches):
Width: 2.3125 (will get truncated to 2.31)
Height 4.00
• Unprintable Area: All 0.00
Advanced Setup
• Operation Mode: Cut
Offset: 0.48 inch
• Paper Type: Die-cut
• Media Settings:
Gap Length: 0.1875 (will get truncated to 0.19) inch
Remaining values: 0.00 inch
Label Y-Offset: 0.30 inch (This should be configured if you are using the 30256 label with the
BadgeDesigner Layout on page 37.)