Operator`s manual

Printer Commands Chapter 5
412 Operators Manual
40
^A
^D COMMAND
23 Change SW3: Software dip switch #3. Below is the ^AB sequence:
12345678
^ABxxxxxxxx
*******. Detect Black Line On Power-up
******.Q 1=Enable Binary Compression, 0=Disable
*****.)Q Always 0
****.))Q Always 0
***.)))Q Always 0
**.))))Q 1=Send Response After Print
** 0=No Response After Print
*.)))))Q 1=Invert >INPUT 1< Polarity, 0=Normal
.))))))Q 1=Disable Extended ASCII, 0=Enable
Position:
1 Extended ASCII: If enabled, characters over 7F hex will be processed.
2 Invert >INPUT 1< Polarity: The >INPUT 1< message is normally returned when
the associated reflective sensor detects a signal. The polarity of this signal
should be inverted when used as a stock level sensor. (This feature is currently
available only on the model 322M printer)
3 Response After Print: If enabled, an enquiry response will be sent back
through the first serial port after every print.
4 Always 0
5 Always 0
6 Always 0
7 Binary Compression: If enabled, the printer will accept downloaded binary
compressed font or graphic files and enquiry responses must be sent using the
five NULL character method.
8 Detect Black Line on Power-up: If this bit is set, the printer will automatically
run a few labels and correctly set the ^D91 value.