Operator`s manual

13-8 428TC Operator’s Manual - 880041-0141
^AB ^D COMMAND
24 Software Bank Switch #4: A non-volatile command used to set the various
functions identified below.
^AB12345678
Position:
1 1 = Enable Slashed Zeros; 0 = Disable
2 1 = External Print Request; 0 = Disable
3 1 = Disable Stock Out Sensing; 0 = Enable
4 1 = Enable Auto-size on Power-up; 0 = Disable
5678 Code Pages:
0000 = Not decoded (8 bit)
0001 = Danish (7 bit)
0010 = 860 (8 bit)
0011 = Spanish (7 bit)
0100 = 850 (8 bit)
0101 = German (7 bit)
0110 = 865 (8 bit)
0111 = Swiss (7 bit)
1000 = 852 (8 bit)
1001 = French (7 bit )
1010 = 863 (8 bit)
1011 = Swedish (7 bit)
1100 = 437 (8 bit)
1101 = Italian (7 bit)
1110 = British (7 bit)
1111 = US English (7 bit)
25 Software Bank Switch #5: A non-volatile command used to set the various
functions identified below.
^AB12345678
Position:
1 1 = Enable Single Button Error Clear; 0 = Disable
2 1 = Display >BUTTON PRESSED<; 0 = Disable
3 1 = TOF sensor is transmissive; 0 = TOF is reflective
4 1 = Enable TOF on Power-up; 0 = Disable
5 1 = Button is TOF; 0 = Button is Defined by SW#2 bit4
6 1 = Enable AutoLoad; 0 = Disable
7 1 = AutoLoad+TOF; 0 = Autoload+FF
8 1 = Enable Status Byte Mode; 0 = Disable