Operator`s manual

Getting Started Chapter 3
3-2 324M/424M Operator’s Manual - 880026-0144
3.2.1 Printer Power
Microcom Corporation offers three (3) different “Desktop” universal power supplies as
options. Any power supply that conforms to the standard supply specifications listed in
Table 3-1 below may be used. The printer requires a universal +24VDC power supply that
operates in the 100-240 VAC; 50-60 Hertz range; 4 Amps. The power supply should
operate in an “output fold-back mode” during an overload situation rather than a shutdown
and restart attempt; sometimes referred to as a “Hiccup” mode. Contact your Microcom
Corporation representative for any questions regarding power adapter requirements and/or
specifications.
AC Input: 100-240 VAC, 50/60 HZ, 4A
DC Output: +24V @ 0.2 ~4.16A +/- 5%
Power Rating:
100 Watts, no cooling, 40°C
Overload Protection: Output Voltage Foldback Mode
Maximum Transient Load:
12 cycles @ 2.1ms rep. rate;
35A, 650µs pulse
Printer Power Connector: Standard 4-pin power mini-DIN
Table 3-1 100 Watt Power Supply, w/o Fan 40°C
AC Input: 100-240 VAC, 50/60 HZ, 4A
DC Output: +24V @ 0.2 ~6.25A +/- 5%
Power Rating:
150 Watts, internal fan cooling, 60°C
Overload Protection: Output Voltage Foldback Mode
Maximum Transient Load:
12 cycles @ 2.1 ms rep. rate;
35A, 650 µs pulse
Printer Power Connector: Standard 4-pin power mini-DIN
Table 3-2 150 Watt Power Supply, with Fan 60°C
AC Input: 100-240 VAC, 50/60HZ, 4A
DC Output: +24V @ 0.2 ~4.16A +/- 5%
Power Rating:
85 Watts, no cooling, 40°C
Overload Protection: Output Voltage Foldback Mode
Maximum Transient Load:
12 cycles @ 2.1ms rep. rate;
35A, 650µs pulse
Printer Power Connector: Standard 4-pin power mini-DIN
Table 3-3 85 Watt Power Supply, w/o Fan 70°C