Specifications

Page 19Installation Instructions: AM-137 Board AM-1600/1400 Upgrade
The B2/B1 location on the rear panel is actually an RJ21 cutout. Your AM-137
installation kit includes an adapter bracket allowing you to install two DB9 connectors
into the RJ21 cutout. The adapter bracket and serial port assembly are shown below:
RJ-21 cutout on the
rear of your Eagle
chassis.
ADAPTER BRACKET
(DWF-20519-04)
AM-314 SERIAL PORTS
MALE / FEMALE 3/16" HEX SCREW
WITH 4-40 THREADS
MC1090
RJ21 to DB9 Conversion Assembly
Attach the DB9 connectors to the rear panel of your computer, using the 3/16" hex-nuts
included in the mounting kit.
Your external SCSI connector attaches to the new rear panel with same phillips-head
screws and bail-lock clips used on the old rear panel.
If you are installing an AM-318 board, its RJ21 connector attaches to the rear panel at
location B2/B1. The connector is secured to the rear panel exactly like your external
SCSI connector. Make sure you read the
AM-318 Eight-Port Serial I/O Board Installation
Instructions
shipped with your order.
Your product installation kit includes metal cover plates for the B2/B1 RJ21 cutout, the
Ethernet cutout, and for the two DB9 cutouts at locations A1 and A2. The metal plates
are designed to cover unused cutouts. Each metal cover plate is held in position with
two screws.
PDI-00137-50, Rev. A01