Specifications

Page 14 Installation Instructions: AM-137 Board AM-1600/1400 Upgrade
BATTERY
PARALLEL PORT
J1
W1
BOOT CONFIGURATION
SWITCH
J5J4
J2
J3
ALPHA MICROSYSTEMS
W4
W5
J8 J9
J6
J7
W10
J11
W11
J10
W13
W14
W7
POWER
RUN
DISK
W8
W12
W9
W6
030
FOUR ON-BOARD (4-7)
RS232 SERIAL PORTS
FOUR ON-BOARD (0-3)
RS232 SERIAL PORTS
POWER
CONNECTOR
OSCILLATOR JUMPERS
DO NOT REMOVE
IDE INTERFACE
SCSI INTERFACE
I/O EXPANSION—SUPPORTS AM-318
AND AM-314 SERIAL I/O BOARDS, AND
THE AM-366 ETHERNET BOARD
MEMORY CONNECTOR
CONNECTOR FOR AM-219
DISKETTE CONTROLLER
DISPLAY
PANEL
SSD
PIN-1
W3
RESET SWITCH
W2
W2 "IN" = REMOTE RESET ENABLED
W2 "OUT" = REMOTE RESET DISABLED (DEFAULT)
ACTIVE SCSI
TERMINATION
W6
W6
ENABLE
DISABLE
W7 W7 W7 W7
4MB
8MB
16MB
32MB
MEMORY CONFIGURATION
FACTORY
USE ONLY
AM-137
MC1151
U28 U29
U14
U15
AM-137 Board Configuration
3.For the desktop chassis, place the AM-137 board in the chassis and align it with
all six nylon locking posts. Gently press down on the AM-137 board until each of
the nylon posts locks the board into position.
For the deskside chassis, remount the AM-137 board to the mounting plate using
the same hardware used by the previous board.
PDI-00137-50, Rev. A01