Specifications

Page 13Installation Instructions: AM-137 Board AM-1600/1400 Upgrade
11.Remove the three phillips-head screws holding the CPU board in place.
12.The installation kit includes a tool allowing you to free the CPU board from the
nylon locking posts. The tool, which is actually hollow metal tube, slides over the
nylon locking post and allows the CPU board to be lifted free.
AM-135 BOARD
NYLON LOCKING
POST
AM-135 REMOVAL TOOL
(DWF-20528-00)
MC1204
CPU Board Removal Tool
Use the tool to release the CPU from all six of the nylon locking posts.
13.Remove the CPU board from the chassis.
14.Remove the four phillips-head screws that secure the I/O adapter plate to your
computer’s rear panel.
15.Remove the I/O adapter plate from the chassis.
8.0INSTALLING THE AM-137 BOARD
1.Your installation kit includes a new I/O adapter plate designed for the AM-137
board. The new I/O adapter plate must be installed before you install the AM-137
board. The same screws that held the old adapter plate in place are used to
secure the new I/O adapter plate. Once the I/O adapter plate is installed, you
ready to install the AM-137 board.
2.Before placing the AM-137 board in the chassis, make sure it is configured
properly for your application. The illustration below shows the AM-137 board
configured as shipped by Alpha Micro. There are only two user configurable
jumpers on this board, the W2 Remote Reset jumper and the W7 memory
configuration jumpers. All other jumpers should be left in their factory configured
positions. All possible configurations for jumpers W2 and W7 are shown in the
illustration.
PDI-00137-50, Rev. A01