Datasheet
Table Of Contents
- 1.0 Introduction
- 2.0 USB3320 Pin Locations and Definitions
- 3.0 Limiting Values
- 4.0 Electrical Characteristics
- 4.1 Operating Current
- 4.2 Clock Specifications
- 4.3 ULPI Interface Timing
- 4.4 Digital IO Pins
- 4.5 DC Characteristics: Analog I/O Pins
- 4.6 Dynamic Characteristics: Analog I/O Pins
- 4.7 OTG Electrical Characteristics
- 4.8 USB Audio Switch Characteristics
- 4.9 Regulator Output Voltages and Capacitor Requirement
- 4.10 Piezoelectric Resonator for Internal Oscillator
- 5.0 Architecture Overview
- FIGURE 5-1: USB3320 Internal Block Diagram
- 5.1 ULPI Digital Operation and Interface
- 5.2 USB 2.0 Hi-Speed Transceiver
- 5.3 Bias Generator
- 5.4 Integrated Low Jitter PLL
- 5.5 Internal Regulators and POR
- 5.6 USB On-The-Go (OTG)
- 5.7 USB UART Support
- 5.8 USB Charger Detection Support
- 5.9 USB Audio Support
- 5.10 Reference Frequency Selection
- 6.0 ULPI Operation
- 6.1 Overview
- 6.2 ULPI Register Access
- 6.3 Low Power Mode
- 6.4 Full Speed/Low Speed Serial Modes
- 6.5 Carkit Mode
- 6.6 RID Converter Operation
- 6.7 Headset Audio Mode
- 7.0 ULPI Register Map
- 8.0 Application Notes
- 8.1 Application Diagram
- TABLE 8-1: Component Values in Application Diagrams
- TABLE 8-2: Capacitance Values at VBUS of USB Connector
- FIGURE 8-1: USB3320 Application Diagram (Device, ULPI Output Clock mode, 24MHz)
- FIGURE 8-2: USB3320 Application Diagram (Device, ULPI Input Clock mode, 60MHz)
- FIGURE 8-3: USB3320 Application Diagram (Host or OTG, ULPI Output Clock Mode, 24MHz)
- 8.2 Reference Designs
- 8.3 ESD Performance
- 8.1 Application Diagram
- 9.0 Package Information
- Appendix A: Data Sheet Revision History
- The Microchip Web Site
- Customer Change Notification Service
- Customer Support
- Product Identification System
- Worldwide Sales and Service
USB3320
DS00001792E-page 2 2014-2016 Microchip Technology Inc.
TO OUR VALUED CUSTOMERS
It is our intention to provide our valued customers with the best documentation possible to ensure successful use of your Microchip
products. To this end, we will continue to improve our publications to better suit your needs. Our publications will be refined and
enhanced as new volumes and updates are introduced.
If you have any questions or comments regarding this publication, please contact the Marketing Communications Department via
E-mail at docerrors@microchip.com. We welcome your feedback.
Most Current Data Sheet
To obtain the most up-to-date version of this data sheet, please register at our Worldwide Web site at:
http://www.microchip.com
You can determine the version of a data sheet by examining its literature number found on the bottom outside corner of any page.
The last character of the literature number is the version number, (e.g., DS30000000A is version A of document DS30000000).
Errata
An errata sheet, describing minor operational differences from the data sheet and recommended workarounds, may exist for cur-
rent devices. As device/documentation issues become known to us, we will publish an errata sheet. The errata will specify the
revision of silicon and revision of document to which it applies.
To determine if an errata sheet exists for a particular device, please check with one of the following:
• Microchip’s Worldwide Web site; http://www.microchip.com
• Your local Microchip sales office (see last page)
When contacting a sales office, please specify which device, revision of silicon and data sheet (include -literature number) you are
using.
Customer Notification System
Register on our web site at www.microchip.com to receive the most current information on all of our products.