Datasheet

.0250 "
.635 mm
.0400 "
1.016 mm
.0500 "
1.270 mm
.0500 "
1.270 mm
.2000 "
5.080 mm
n.0390 "`.0030
n.991 mm`.076
n.0310 "`.0030
n.787 mm`.076
NON-PLATED
THRU HOLE
ALIGNMENT PIN HOLES
CONDUCTIVE
CONTACT PADS
NO SOLDER PASTE
PCB TOP LAYER
1
2
5
6
A
REV
DWG NO.SIZE FSCM NO.
TC2030-MCP-NL
MS
SCALE 11:1 SHEET 1 Of 3
REV
A
Notes:
1. No tracks or vias in the shaded "KEEP OUT" AREA.
2. No other track or signal within 0.020" of any contact pad.
3. Do not allow solder paste on the contact pads. It is essential
to eliminate any hole in the solder paste-mask (solder stencil)
layer. If this is not possible make the contact pads thru-hole
with finished hole size of 0.008" or less.
4. To avoid ordering confusion, please specify DNL in your BOM.
www.TAG-CONNECT.com
5. The TC2030-CLIP board can attach to the three
alignment pins from underneath the PCB to
temporarily retain the cable in place.
Microchip ICD / ICSP signals
Pin 1: MCLR / Vpp
Pin 2: Vdd
Pin 3: GND
Pin 4: PGD (ICSPDAT)
Pin 5: PGC (ICSPCLK)
Pin 6: Unused / LVP
FOOTPRINT FOR
TC2030-MCP-NL-FP
12/2/10
FOOTPRINT FOR TC2030-MCP-NL PLUG-OF-NAILS
(TM)
CABLE
"KEEP OUT" AREA