User Manual

Getting Started
 2013 Microchip Technology Inc. DS50002183A-page 23
FIGURE 2-4: FINDING THE COM PORT NUMBER IN WINDOWS
2.4.3.2 ENTER COMMAND MODE
The following are the steps to enter the Command mode in a terminal emulator:
1. Type $$$ on the keyboard sequentially with no additional characters before or
after each $ sign. The module replies with CMD (on terminal emulator) to indicate
it is in Command mode.
2. Type show net <cr> to display the current network settings (Figure 2-5 shows
the current network settings for the version 2.28).
FIGURE 2-5: CURRENT NETWORK SETTINGS
Note: When a command is completed, the terminal displays a prompt in the for-
mat <X.XX>, where X.XX indicates the module’s firmware version.