Datasheet

 2015 Microchip Technology Inc. Preliminary DS60001320B-page 615
PIC32MZ Embedded Connectivity with Floating Point Unit (EF) Family
TABLE 37-7: DC CHARACTERISTICS: IDLE CURRENT (IIDLE)
DC CHARACTERISTICS
Standard Operating Conditions: 2.1V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for Industrial 
-40°C  T
A  +125°C for Extended
Parameter
No.
Typical
(2)
Maximum
(4)
Units Conditions
Idle Current (I
IDLE): Core Off, Clock on Base Current (Note 1)
DC30a 7 22 mA 4 MHz (Note 3)
DC31a 8 24 mA 10 MHz
DC32a 13 32 mA 60 MHz (Note 3)
DC33a 21 42 mA 130 MHz (Note 3)
DC34 26 48 mA 180 MHz (Note 3)
DC35 28 52 mA 200 MHz
Note 1: The test conditions for I
IDLE current measurements are as follows:
• Oscillator mode is EC (for 8 MHz and below) and EC+PLL (for above 8 MHz) with OSC1 driven by
external square wave from rail-to-rail, (OSC1 input clock input over/undershoot < 100 mV required)
• OSC2/CLKO is configured as an I/O input pin
• USB PLL is disabled (USBPMD = 1), V
USB3V3 is connected to VSS, PBCLKx divisor = 1:128 (‘x’  7)
• CPU is in Idle mode (CPU core Halted)
• L1 Cache and Prefetch modules are disabled
• No peripheral modules are operating, (ON bit = 0), but the associated PMD bit is cleared (except
USBPMD)
• WDT, DMT, Clock Switching, Fail-Safe Clock Monitor, and Secondary Oscillator are disabled
• All I/O pins are configured as inputs and pulled to V
SS
•MCLR = VDD
• RTCC and JTAG are disabled
2: Data in “Typical” column is at 3.3V, +25°C unless otherwise stated. Parameters are for design guidance
only and are not tested.
3: This parameter is characterized, but not tested in manufacturing.
4: Data in the “Maximum” column is at 3.3V, +85ºC at specified operating frequency, unless otherwise stated.
Parameters are for design guidance only and are not tested.