Datasheet

 2015 Microchip Technology Inc. Preliminary DS60001320B-page 223
PIC32MZ Embedded Connectivity with Floating Point Unit (EF) Family
bit 26
DATATWEN: Data Toggle Write Enable Control bit (Host mode)
1 = DATATGGL can be written
0 = DATATGGL is not writable
bit 25
DATATGGL: Data Toggle bit (Host mode)
When read, this bit indicates the current state of the endpoint data toggle.
If DATATWEN = 1, this bit may be written with the required setting of the data toggle.
If DATATWEN = 0, any value written to this bit is ignored.
bit 24
INCOMPRX: Incomplete Packet Status bit
1 = The packet in the RX FIFO during a high-bandwidth Isochronous/Interrupt transfer is incomplete because
parts of the data were not received
0 = Written by then software to clear this bit
In anything other than Isochronous transfer, this bit will always return 0.
bit 23
CLRDT: Clear Data Toggle Control bit
1 = Reset the endpoint data toggle to 0
0 = Leave endpoint data toggle alone
bit 22
SENTSTALL: STALL Handshake Status bit (Device mode)
1 = STALL handshake is transmitted
0 = Written by the software to clear this bit
RXSTALL: STALL Handshake Receive Status bit (Host mode)
1 = A STALL handshake has been received. An interrupt is generated.
0 = Written by the software to clear this bit
bit 21
SENDSTALL: STALL Handshake Control bit (Device mode)
1 = Issue a STALL handshake
0 = Terminate stall condition
REQPKT: IN Transaction Request Control bit (Host mode)
1 = Request an IN transaction.
0 = No request
This bit is cleared when RXPKTRDY is set.
bit 20
FLUSH: Flush FIFO Control bit
1 = Flush the next packet to be read from the endpoint RX FIFO. The FIFO pointer is reset and the
RXPKTRDY bit is cleared. This should only be used when RXPKTRDY is set. If the FIFO is double-
buffered, FLUSH may need to be set twice to completely clear the FIFO.
0 = Normal FIFO operation
This bit is automatically cleared.
bit 19
DATAERR: Data Packet Error Status bit (Device mode)
1 = The data packet has a CRC or bit-stuff error.
0 = No data error
This bit is cleared when RXPKTRDY is cleared. This bit is only valid when the endpoint is operating in ISO
mode. In Bulk mode, it always returns zero.
DERRNAKT: Data Error/NAK Time-out Status bit (Host mode)
1 = The data packet has a CRC or bit-stuff error. In Bulk mode, the RX endpoint is halted following the receipt
of NAK responses for longer than the time set as the NAK limit.
0 = No data or NAK time-out error
REGISTER 11-9: USBIENCSR1: USB INDEXED ENDPOINT CONTROL STATUS REGISTER 1
(ENDPOINT 1-7) (CONTINUED)