Datasheet

PIC24FV32KA304 FAMILY
DS30009995E-page 212  2011-2017 Microchip Technology Inc.
REGISTER 22-2: AD1CON2: A/D CONTROL REGISTER 2
R/W-0 R/W-0 R/W-0 r-0 R/W-0 R/W-0 U-0 U-0
PVCFG1 PVCFG0 NVCFG0 — BUFREGEN CSCNA — —
bit 15 bit 8
R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0
BUFS
(1)
SMPI4 SMPI3 SMPI2 SMPI1 SMPI0 BUFM
(1)
ALTS
bit 7 bit 0
Legend: r = Reserved bit
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
bit 15-14
PVCFG<1:0>: Converter Positive Voltage Reference Configuration bits
11 = 4 * Internal V BG
(2)
10 = 2 * Internal V BG
(3)
01 =External V REF +
00 =AV
DD
bit 13 NVCFG0: Converter Negative Voltage Reference Configuration bits
1 =External V REF -
0 =AV
SS
bit 12 Reserved: Maintain as ‘0’
bit 11
BUFREGEN: A/D Buffer Register Enable bit
1 = Conversion result is loaded into a buffer location determined by the converted channel
0 = A/D result buffer is treated as a FIFO
bit 10
CSCNA: Scan Input Selections for CH0+ S/H Input for MUX A Setting bit
1 =Scans inputs
0 = Does not scan inputs
bit 9-8
Unimplemented: Read as ‘0’
bit 7 BUFS: Buffer Fill Status bit
(1)
1 = A/D is filling the upper half of the buffer; user should access data in the lower half
0 = A/D is filling the lower half of the buffer; user should access data in the upper half
bit 6-2
SMPI<4:0>: Sample Rate Interrupt Select bits
11111 = Interrupts at the completion of the conversion for each 32nd sample
11110 = Interrupts at the completion of the conversion for each 31st sample
•
•
•
00001 = Interrupts at the completion of the conversion for every other sample
00000 = Interrupts at the completion of the conversion for each sample
bit 1
BUFM: Buffer Fill Mode Select bit
(1)
1 = Starts filling the buffer at address, AD1BUF0, on the first interrupt and AD1BUF(n/2) on the next
interrupt (Split Buffer mode)
0 = Starts filling the buffer at address, ADCBUF0, and each sequential address on successive
interrupts (FIFO mode)
Note 1: This is only applicable when the buffer is used in FIFO mode (BUFREGEN = 0). In addition, BUFS is only
used when BUFM = 1.
2: The voltage reference setting will not be within the specification with V DD below 4.5V.
3: The voltage reference setting will not be within the specification with V DD below 2.3V.