Datasheet

PIC24FJ256GA110 FAMILY
DS30009905F-page 300  2007-2019 Microchip Technology Inc.
FIGURE 28-20: I
2
C BUS DATA TIMING CHARACTERISTICS (SLAVE MODE)
TABLE 28-32: I
2
C BUS DATA TIMING REQUIREMENTS (SLAVE MODE)
AC CHARACTERISTICS
Standard Operating Conditions: 2.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  T
A  +85°C (Industrial)
Param
No.
Symbol Characteristic Min Max Units Conditions
IS10 TLO:SCL Clock Low Time 100 kHz mode 4.7 — µs Device must operate at a
minimum of 1.5 MHz
400 kHz mode 1.3 — µs Device must operate at a
minimum of 10 MHz
1 MHz mode
(1)
0.5 — µs
IS11 THI:SCL Clock High Time 100 kHz mode 4.0 — µs Device must operate at a
minimum of 1.5 MHz
400 kHz mode 0.6 — µs Device must operate at a
minimum of 10 MHz
1 MHz mode
(1)
0.5 — µs
IS20 TF:SCL SDAx and SCLx
Fall Time
100 kHz mode — 300 ns CB is specified to be from
10 to 400 pF
400 kHz mode 20 + 0.1 CB 300 ns
1 MHz mode
(1)
—100ns
IS21 TR:SCL SDAx and SCLx
Rise Time
100 kHz mode — 1000 ns CB is specified to be from
10 to 400 pF
400 kHz mode 20 + 0.1 CB 300 ns
1 MHz mode
(1)
—300ns
IS25 T
SU:DAT Data Input
Setup Time
100 kHz mode 250 — ns
400 kHz mode 100 — ns
1 MHz mode
(1)
100 — ns
IS26 T
HD:DAT Data Input
Hold Time
100 kHz mode 0 — ns
400 kHz mode 0 0.9 µs
1 MHz mode
(1)
00.3µs
IS40 T
AA:SCL Output Valid From
Clock
100 kHz mode 0 3500 ns
400 kHz mode 0 1000 ns
1 MHz mode
(1)
0350ns
IS45 TBF:SDA Bus Free Time 100 kHz mode 4.7 — µs Time the bus must be free
before a new transmission
can start
400 kHz mode 1.3 — µs
1 MHz mode
(1)
0.5 — µs
IS50 CB Bus Capacitive Loading — 400 pF
Note 1: Maximum pin capacitance = 10 pF for all I
2
C pins (for 1 MHz mode only).
SCLx
SDAx
In
SDAx
Out
IS11
IS10
IS20
IS25
IS40
IS21
IS26
IS45