Datasheet

 2011 Microchip Technology Inc. DS39762F-page 45
PIC18F97J60 FAMILY
2.4 Voltage Regulator Pins (ENVREG
and V
CAP/VDDCORE)
The on-chip voltage regulator enable pin, ENVREG,
must always be connected directly to either a supply
voltage or to ground. Tying ENVREG to VDD enables
the regulator, while tying it to ground disables the
regulator. Refer to Section 25.3 “On-Chip Voltage
Regulator” for details on connecting and using the
on-chip regulator.
When the regulator is enabled, a low-ESR (< 5Ω)
capacitor is required on the V
CAP/VDDCORE pin to
stabilize the voltage regulator output voltage. The
V
CAP/VDDCORE pin must not be connected to VDD and
must use a capacitor of 10 µF connected to ground. The
type can be ceramic or tantalum. Suitable examples of
capacitors are shown in Ta ble 2- 1 . Capacitors with
equivalent specifications can be used.
Designers may use Figure 2-3 to evaluate ESR
equivalence of candidate devices.
It is recommended that the trace length not exceed
0.25 inch (6 mm). Refer to 28.0 “Electrical
Characteristics” for additional information.
When the regulator is disabled, the V
CAP/VDDCORE pin
must be tied to a voltage supply at the V
DDCORE level.
Refer to 28.0 “Electrical Characteristics” for
information on VDD and VDDCORE.
Note that the “LF” versions of some low pin count
PIC18FJ parts (e.g., the PIC18LF45J10) do not have
the ENVREG pin. These devices are provided with the
voltage regulator permanently disabled; they must
always be provided with a supply voltage on the
V
DDCORE pin.
FIGURE 2-3: FREQUENCY vs. ESR
PERFORMANCE FOR
SUGGESTED V
CAP
.
10
1
0.1
0.01
0.001
0.01 0.1 1 10 100 1000 10,000
Frequency (MHz)
ESR ()
Note: Typical data measurement at 25°C, 0V DC bias.
TABLE 2-1: SUITABLE CAPACITOR EQUIVALENTS
Make Part #
Nominal
Capacitance
Base Tolerance Rated Voltage Temp. Range
TDK C3216X7R1C106K 10 µF ±10% 16V -55 to 125ºC
TDK C3216X5R1C106K 10 µF ±10% 16V -55 to 85ºC
Panasonic ECJ-3YX1C106K 10 µF ±10% 16V -55 to 125ºC
Panasonic ECJ-4YB1C106K 10 µF ±10% 16V -55 to 85ºC
Murata GRM32DR71C106KA01L 10 µF ±10% 16V -55 to 125ºC
Murata GRM31CR61C106KC31L 10 µF ±10% 16V -55 to 85ºC