Datasheet

PIC18F97J60 FAMILY
DS39762F-page 188  2011 Microchip Technology Inc.
16.2 Timer4 Interrupt
The Timer4 module has an 8-Bit Period register, PR4,
which is both readable and writable. Timer4 increments
from 00h until it matches PR4 and then resets to 00h on
the next increment cycle. The PR4 register is initialized
to FFh upon Reset.
16.3 Output of TMR4
The output of TMR4 (before the postscaler) is used
only as a PWM time base for the CCPx/ECCPx mod-
ules. It is not used as a baud rate clock for the MSSPx
modules as is the Timer2 output.
FIGURE 16-1: TIMER4 BLOCK DIAGRAM
TABLE 16-1: REGISTERS ASSOCIATED WITH TIMER4 AS A TIMER/COUNTER
Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Reset
Values
on Page:
INTCON GIE/GIEH PEIE/GIEL
TMR0IE INT0IE RBIE TMR0IF INT0IF RBIF 69
IPR3 SSP2IP BCL2IP RC2IP TX2IP TMR4IP CCP5IP CCP4IP CCP3IP 71
PIR3 SSP2IF BCL2IF RC2IF TX2IF TMR4IF CCP5IF CCP4IF CCP3IF 71
PIE3
SSP2IE BCL2IE RC2IE TX2IE TMR4IE CCP5IE CCP4IE CCP3IE 71
TMR4 Timer4 Register 72
T4CON — T4OUTPS3 T4OUTPS2 T4OUTPS1 T4OUTPS0 TMR4ON T4CKPS1 T4CKPS0 72
PR4 Timer4 Period Register 72
Legend: — = unimplemented, read as ‘0’. Shaded cells are not used by the Timer4 module.
Comparator
TMR4 Output
TMR4
Postscaler
Prescaler
PR4
2
F
OSC/4
1:1 to 1:16
1:1, 1:4, 1:16
4
T4OUTPS<3:0>
T4CKPS<1:0>
Set TMR4IF
Internal Data Bus
8
Reset
TMR4/PR4
8
8
(to PWM)
Match