Datasheet

PIC18F2480/2580/4480/4580
DS39637A-page 436 Preliminary  2004 Microchip Technology Inc.
FIGURE 27-6: CLKO AND I/O TIMING
TABLE 27-9: CLKO AND I/O TIMING REQUIREMENTS
Note: Refer to Figure 27-4 for load conditions.
OSC1
CLKO
I/O pin
(Input)
I/O pin
(Output)
Q4
Q1
Q2 Q3
10
13
14
17
20, 21
19
18
15
11
12
16
Old Value
New Value
Param
No.
Symbol Characteristic Min Typ Max Units Conditions
10 T
OSH2CKLOSC1 ↑ to CLKO ↓ — 75 200 ns (Note 1)
11 TOSH2CKHOSC1 ↑ to CLKO ↑ — 75 200 ns (Note 1)
12 T
CKR CLKO Rise Time — 35 100 ns (Note 1)
13 TCKF CLKO Fall Time — 35 100 ns (Note 1)
14 TCKL2IOVCLKO ↓ to Port Out Valid — — 0.5 TCY + 20 ns (Note 1)
15 T
IOV2CKH Port In Valid before CLKO ↑ 0.25 TCY + 25 — — ns (Note 1)
16 TCKH2IOI Port In Hold after CLKO ↑ 0——ns(Note 1)
17 TOSH2IOVOSC1 ↑ (Q1 cycle) to Port Out Valid — 50 150 ns
18 T
OSH2IOIOSC1 ↑ (Q2 cycle) to Port
Input Invalid (I/O in hold
time)
PIC18FXXXX 100 — — ns
18A PIC18LFXXXX 200 — — ns V
DD = 2.0V
19 TIOV2OSH Port Input Valid to OSC1 ↑ (I/O in
setup time)
0——ns
20 T
IOR Port Output Rise Time PIC18FXXXX — 10 25 ns
20A PIC18LFXXXX — — 60 ns V
DD = 2.0V
21 TIOF Port Output Fall Time PIC18FXXXX — 10 25 ns
21A PIC18LFXXXX — — 60 ns VDD = 2.0V
22† T
INP INT pin High or Low Time TCY ——ns
23† TRBP RB7:RB4 Change INT High or Low Time TCY ——ns
24† TRCP RC7:RC4 Change INT High or Low Time 20 ns
† These parameters are asynchronous events not related to any internal clock edges.
Note 1: Measurements are taken in RC mode, where CLKO output is 4 x TOSC.