Datasheet

PIC18(L)F2X/4XK22
DS40001412G-page 214  2010-2016 Microchip Technology Inc.
15.2.6 SPI OPERATION IN SLEEP MODE
In SPI Master mode, module clocks may be operating
at a different speed than when in Full-Power mode; in
the case of the Sleep mode, all clocks are halted.
Special care must be taken by the user when the
MSSPx clock is much faster than the system clock.
In Slave mode, when MSSPx interrupts are enabled,
after the master completes sending data, an MSSPx
interrupt will wake the controller from Sleep.
If an exit from Sleep mode is not desired, MSSPx
interrupts should be disabled.
In SPI Master mode, when the Sleep mode is selected,
all module clocks are halted and the transmission/
reception will remain in that state until the device
wakes. After the device returns to Run mode, the
module will resume transmitting and receiving data.
In SPI Slave mode, the SPI Transmit/Receive Shift
register operates asynchronously to the device. This
allows the device to be placed in Sleep mode and data
to be shifted into the SPI Transmit/Receive Shift
register. When all eight bits have been received, the
MSSPx interrupt flag bit will be set and if enabled, will
wake the device.
TABLE 15-1: REGISTERS ASSOCIATED WITH SPI OPERATION
Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Register
on Page
ANSELA
— —
ANSA5
—
ANSA3 ANSA2 ANSA1 ANSA0 149
ANSELB
— —
ANSB5 ANSB4 ANSB3
(1)
ANSB2
(1)
ANSB1
(1)
ANSB0
(1)
150
ANSELC
ANSC7 ANSC6 ANSC5 ANSC4 ANSC3 ANSC2
— —
150
ANSELD
ANSD7 ANSD6 ANSD5 ANSD4
(2)
ANSD3
(2)
ANSD2 ANSD1
(2)
ANSD0
(2)
150
INTCON GIE/GIEH PEIE/GIEL TMR0IE INT0IE RBIE TMR0IF INT0IF RBIF 109
IPR1
—
ADIP RC1IP TX1IP SSP1IP CCP1IP TMR2IP TMR1IP 121
IPR3 SSP2IP
BCL2IP RC2IP TX2IP CTMUIP TMR5GIP TMR3GIP TMR1GIP 123
PIE1
—
ADIE RC1IE TX1IE SSP1IE CCP1IE TMR2IE TMR1IE 117
PIE3 SSP2IE
BCL2IE RC2IE TX2IE CTMUIE TMR5GIE TMR3GIE TMR1GIE 119
PIR1
—
ADIF RC1IF TX1IF SSP1IF CCP1IF TMR2IF TMR1IF 112
PIR3 SSP2IF
BCL2IF RC2IF TX2IF CTMUIF TMR5GIF TMR3GIF TMR1GIF 114
PMD1 MSSP2MD MSSP1MD
—
CCP5MD CCP4MD CCP3MD CCP2MD CCP1MD 53
SSP1BUF SSP1 Receive Buffer/Transmit Register
—
SSP1CON1 WCOL SSPOV SSPEN CKP SSPM<3:0> 253
SSP1CON3
ACKTIM PCIE SCIE BOEN SDAHT SBCDE AHEN DHEN 256
SSP1STAT SMP CKE D/A P S R/W UA BF 252
SSP2BUF SSP2 Receive Buffer/Transmit Register
—
SSP2CON1 WCOL SSPOV SSPEN CKP SSPM<3:0> 253
SSP2CON3
ACKTIM PCIE SCIE BOEN SDAHT SBCDE AHEN DHEN 256
SSP2STAT SMP CKE D/A P S R/W UA BF 252
TRISA
TRISA7 TRISA6 TRISA5 TRISA4 TRISA3 TRISA2 TRISA1 TRISA0 151
TRISB TRISB7 TRISB6 TRISB5 TRISB4 TRISB3
(1)
TRISB2
(1)
TRISB1
(1)
TRISB0
(1)
151
TRISC
TRISC7 TRISC6 TRISC5 TRISC4 TRISC3 TRISC2 TRISC1 TRISC0 151
TRISD TRISD7 TRISD6 TRISD5 TRISD4
(2)
TRISD3
(2)
TRISD2 TRISD1
(2)
TRISD0
(2)
151
Legend: Shaded bits are not used by the MSSPx in SPI mode.
Note 1: PIC18(L)F2XK22 devices.
2: PIC18(L)F4XK22 devices.