Datasheet

 2010-2015 Microchip Technology Inc. DS40001303H-page 377
PIC18F2XK20/4XK20
FIGURE 26-14: EXAMPLE SPI SLAVE MODE TIMING (CKE = 0)
SS
SCK
(CKP = 0)
SCK
(CKP = 1)
SDO
SDI
70
71 72
73
74
75, 76
77
78
79
80
79
78
SDI
MSb LSb
bit 6 - - - - - -1
MSb In
bit 6 - - - -1 LSb In
83
Note: Refer to Figure 26-4 for load conditions.
TABLE 26-27: EXAMPLE SPI MODE REQUIREMENTS (SLAVE MODE TIMING, CKE = 0)
Param.
No.
Symbol Characteristic Min. Max. Units Conditions
70 TssL2scH,
TssL2scL
SS
 to SCK  or SCK  Input TCY —ns
71 TscH SCK Input High Time
(Slave mode)
Continuous 1.25 T
CY + 30 — ns
71A Single Byte 40 — ns (Note 1)
72 TscL SCK Input Low Time
(Slave mode)
Continuous 1.25 T
CY + 30 — ns
72A Single Byte 40 — ns (Note 1)
73 TdiV2scH,
TdiV2scL
Setup Time of SDI Data Input to SCK Edge 100 — ns
73A Tb2b Last Clock Edge of Byte 1 to the First Clock Edge of
Byte 2
1.5 T
CY + 40 — ns (Note 2)
74 TscH2diL,
TscL2diL
Hold Time of SDI Data Input to SCK Edge 100 — ns
75 TdoR SDO Data Output Rise Time — 25 ns
76 TdoF SDO Data Output Fall Time — 25 ns
77 TssH2doZ SS
 to SDO Output High-Impedance 10 50 ns
78 TscR SCK Output Rise Time (Master mode) — 25 ns
79 TscF SCK Output Fall Time (Master mode) — 25 ns
80 TscH2doV,
TscL2doV
SDO Data Output Valid after SCK Edge — 50 ns
83 TscH2ssH,
TscL2ssH
SS
 after SCK edge 1.5 TCY + 40 — ns
Note 1: Requires the use of Parameter #73A.
2: Only if Parameter #71A and #72A are used.