Datasheet

 2009-2016 Microchip Technology Inc. DS40001365F-page 331
PIC18(L)F1XK22
TABLE 26-7: SECONDARY IDLE SUPPLY CURRENT
PIC18LF1XK22
Standard Operating Conditions (unless otherwise stated)
PIC18F1XK22
Standard Operating Conditions (unless otherwise stated)
Param.
No.
Device Characteristics Typ. Max. Units Conditions
D023
Supply Current (I
DD)
(1, 2, 4)
25A-40°C
V
DD = 1.8V
F
OSC = 32 kHz
(3)
(SEC_IDLE mode,
Timer1 as clock)
25A+25°C
39A+85°C
811A +125°C
D023A 4 8 A-40°C
V
DD = 3.0V
510A+25°C
920A+85°C
20 23 A +125°C
D023 20 40 A -40°C
VDD = 2.3V
FOSC = 32 kHz
(3)
(SEC_IDLE mode,
Timer1 as clock)
21 41 A +25°C
23 44 A +85°C
24 47 A +125°C
D023A 23 45 A -40°C
VDD = 3.0V
25 47 A +25°C
28 49 A +85°C
30 52 A +125°C
D023B 28 50 A -40°C
VDD = 5.0V
30 54 A +25°C
32 59 A +85°C
33 62 A +125°C
* These parameters are characterized but not tested.
Note 1: The test conditions for all I
DD measurements in active operation mode are: OSC1 = external square wave, from
rail-to-rail; all I/O pins tri-stated, pulled to V
DD; MCLR = VDD; WDT disabled.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O pin
loading and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact
on the current consumption.
3: For RC oscillator configurations, current through REXT is not included. The current through the resistor can be
extended by the formula I
R = VDD/2REXT (mA) with REXT in k
4: FVR and BOR are disabled.