Datasheet
PIC18(L)F1XK22
DS40001365F-page 330 2009-2016 Microchip Technology Inc.
TABLE 26-6: SECONDARY RUN SUPPLY CURRENT
PIC18LF1XK22
Standard Operating Conditions (unless otherwise stated)
PIC18F1XK22
Standard Operating Conditions (unless otherwise stated)
Param.
No.
Device Characteristics Typ. Max. Units Conditions
D022
Supply Current (IDD)
(1, 2, 4)
69A-40°C
V
DD = 1.8V
F
OSC = 32 kHz
(3)
(SEC_RUN mode,
Timer1 as clock)
610A+25°C
714A+85°C
11 17 A +125°C
D022A 11 15 A-40°C
V
DD = 3.0V
11 16 A+25°C
12 25 A+85°C
26 28 A +125°C
D022 22 65 A -40°C
VDD = 2.3V
FOSC = 32 kHz
(3)
(SEC_RUN mode,
Timer1 as clock)
23 67 A +25°C
25 69 A +85°C
28 75 A +125°C
D022A 25 70 A -40°C
VDD = 3.0V
27 72 A +25°C
30 74 A +85°C
32 77 A +125°C
D022B 30 75 A -40°C
VDD = 5.0V
32 77 A +25°C
34 79 A +85°C
35 83 A +125°C
* These parameters are characterized but not tested.
Note 1: The test conditions for all I
DD measurements in active operation mode are: OSC1 = external square wave, from
rail-to-rail; all I/O pins tri-stated, pulled to V
DD; MCLR = VDD; WDT disabled.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O pin
loading and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact
on the current consumption.
3: For RC oscillator configurations, current through REXT is not included. The current through the resistor can be
extended by the formula I
R = VDD/2REXT (mA) with REXT in k
4: FVR and BOR are disabled.