Datasheet

 2009-2016 Microchip Technology Inc. DS40001365F-page 329
PIC18(L)F1XK22
TABLE 26-5: PRIMARY IDLE SUPPLY CURRENT
PIC18LF1XK22
Standard Operating Conditions (unless otherwise stated)
PIC18F1XK22
Standard Operating Conditions (unless otherwise stated)
Param.
No.
Device Characteristics Typ. Max. Units Conditions
D019
Supply Current (I
DD)
(1, 2, 4, 5)
70
105
A
-40°C to +125°C V
DD = 1.8V
F
OSC = 1 MHz
(PRI_IDLE mode,
EC Med Osc)
D019A
140
180
A
-40°C to +125°C V
DD = 3.0V
D019
80
120
A
-40°C to +125°C VDD = 2.3V
FOSC = 1 MHz
(PRI_IDLE mode,
EC Med Osc)
D019A
140
180
A
-40°C to +125°C VDD = 3.0V
D019B
151
230
A
-40°C to +125°C VDD = 5.0V
D020
1.0
1.8
mA
-40°C to +125°C V
DD = 1.8V
F
OSC = 16 MHz
(PRI_IDLEmode,
EC High Osc)
D020A
1.2
2.0
mA
-40°C to +125°C V
DD = 3.0V
D020
1.0
1.8
mA
-40°C to +125°C VDD = 2.3V
FOSC = 16 MHz
(PRI_IDLEmode,
EC High Osc)
D020A
1.2
2.0
mA
-40°C to +125°C VDD = 3.0V
D020B
1.4
2.1
mA
-40°C to +125°C VDD = 5.0V
D021
5.0
7.0
mA
-40°C to +125°C V
DD = 3.0V
F
OSC = 64 MHz
(PRI_IDLEmode,
EC High Osc)
D021
5.2
6.2
mA
-40°C to +125°C VDD = 3.0V
FOSC = 64 MHz
(PRI_IDLEmode,
EC High Osc)
D021A
5.3
6.3
mA
-40°C to +125°C VDD = 5.0V
* These parameters are characterized but not tested.
Note 1: The test conditions for all IDD measurements in active operation mode are: OSC1 = external square wave, from
rail-to-rail; all I/O pins tri-stated, pulled to V
DD; MCLR = VDD; WDT disabled.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O pin
loading and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact
on the current consumption.
3: For RC oscillator configurations, current through REXT is not included. The current through the resistor can be
extended by the formula I
R = VDD/2REXT (mA) with REXT in k
4: FVR and BOR are disabled.
5: When a single temperature range is provided for a parameter, the specification applies to both industrial and extended
temperature devices.