Datasheet

 2011 Microchip Technology Inc. Preliminary DS41441B-page 331
PIC12(L)F1840
Power-down Base Current (IPD) in Low-Power Sleep mode
(2)
— 0.04
0.2
0.27
3.5
4
4.5
3.5
4
4.5
A 2.3
3.0
5.0
Base
— — — — A 2.3
3.0
5.0
FVR Enabled
— — — — A 2.3
3.0
5.0
BOR Enabled
— — — — A 2.3
3.0
5.0
Comparator Enabled
(HP mode)
— — — — A 2.3
3.0
5.0
Comparator Enabled
(LP mode)
30.3 DC Characteristics: PIC12(L)F1840-I/E (Power-Down) (Continued)
PIC12LF1840
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
-40°C  T
A  +125°C for extended
PIC12F1840
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for industrial
-40°C  T
A  +125°C for extended
Param
No.
Device Characteristics Min. Typ†
Max.
+85°C
Max.
+125°C
Units
Conditions
V
DD Note
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are
not tested.
Note 1: The peripheral current is the sum of the base I
DD or IPD and the additional current consumed when this peripheral is
enabled. The peripheral  current can be determined by subtracting the base I
DD or IPD current from this limit. Max
values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
DD.
3: A/D oscillator source is F
RC.