Datasheet

 2011-2015 Microchip Technology Inc. DS40001615C-page 221
PIC12(L)F1501
FIGURE 27-5: CLOCK TIMING
TABLE 27-7: CLOCK OSCILLATOR TIMING REQUIREMENTS
Standard Operating Conditions (unless otherwise stated)
Param.
No.
Sym. Characteristic Min. Typ† Max. Units Conditions
OS01 F
OSC External CLKIN Frequency
(1)
DC — 0.5 MHz External Clock (ECL)
DC — 4 MHz
External Clock (ECM)
DC — 20 MHz
External Clock (ECH)
OS02 T
OSC External CLKIN Period
(1)
50 —  ns External Clock (EC)
OS03 T
CY Instruction Cycle Time
(1)
200 TCY DC ns TCY = 4/FOSC
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are not
tested.
Note 1: Instruction cycle period (T
CY) equals four times the input oscillator time base period. All specified values are based on
characterization data for that particular oscillator type under standard operating conditions with the device executing code.
Exceeding these specified limits may result in an unstable oscillator operation and/or higher than expected current con-
sumption. All devices are tested to operate at “min” values with an external clock applied to CLKIN pin. When an external
clock input is used, the “max” cycle time limit is “DC” (no clock) for all devices.
CLKIN
CLKOUT
Q4 Q1 Q2 Q3 Q4 Q1
OS02
OS03
(CLKOUT mode)
Note: See Tab le 27-9.
OS11
OS12